Impulse 463E Instrukcja Użytkownika Pobierz pdf (Strona 24)

- 21 -

SeaI/O User Manual

SeaI/O-470 Jumper and Dipswitch Settings Instructions

The SeaI/O-470 module ships factory configured with the D/A outputs set for 0-10V

and current loop mode on the A/D inputs disabled. If you need to enable current loop

mode or set the D/A outputs to 0-5V, you will need to open the enclosure and access

the jumpers (shown on the next page).

NOTE:

Do not perform these instructions with the power connected. Be

sure to follow proper ESD procedures by grounding yourself and the

SeaI/O module.

What you will need:

 SeaI/O-470 module

 Phillips head screwdriver

 Slotted screwdriver

Step 1

Remove the terminal block from the left side and

then remove the two black screws from each side

of the module as shown in the image.

Step 2

On the front right side of the module, wedge a

slotted screwdriver between the top and bottom

halves as shown. Pry upwards – a pem in the top

half must clear the metal lip in the bottom half of

the enclosure.

Jumpers and dipswitch locations are shown on the

following page.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 108 109

Brak uwag

Impulse 463E Instrukcja Użytkownika Strona 24